Baffled With The Door

[Paul Dennis]

I have done a range this morning and could not get the glass out , glass is slide out but it hits the control panel ,you can't get to the screws for the hindges and the Manuel doesn't say as the customer had looked .

 

[Paul Pantony]

Paul as you open the doors there is a point on the hinges where a gap lines up and the whole door lifts off. Once its off you can just slide the glass out.
On the front edge of the oven just above the hinge there is sometimes an L shaped plate, you need to loosen the screw in this plate and slide it out the way, then the door can be lifted off.
The bottom of the door pivots on a pin, its the top hinge you need to look at when lining the hinge up. Just be careful, they can be a bugger to get back on.

 

[Mike Jones]

Good knowledge!

 

[Paul Pantony]

I can see the screw on your picture from here where I have badly marked it (its up a bit from my red mark). Undo this and the plate will slide over, then open the door and lift.
I am not responsible for it going back on without swearing though! Some easy some not, depends if the hole where it pivots is worn.
Hope this helps.
Paul

 

[Chris Carter]

Looks to me like the door can't open enough due to the draws next to it.
I've had a few like this and usually just easing it forward a bit makes the difference.

Or what Paul said

 

[Paul Dennis]

Thank you for the replies , @Paul Pantony I did take that plate off and tried to lift the door but it just would not move
so I had to use a rod and a radiator cleaner and customer was very happy

 

[Paul Pantony]

Shame, just needed to align it and it would have come off. Never mind, one for the bank for next time.
Best wishes
Paul

 

[Duncan McIver]

This model is now obsolete , it can be tricky but there's a knack to it. I have a six months call back on one of these because the oven cleaner before me ,couldn't get it back on properly.